Custom moving aggregator (without using loops) Possible?

[gonhaddock]

Hello @Felipereis50
Sorry for my late answer but, I’m currently too busy, and no spare time for community challenges.

I had a previously unpublished challenge solution for the following topic; however by the time it was ready, there was already a couple functional workflows by @takbb and @iCFO , so I just keep it for myself at that time…

General summase

@iCFO @takbb Good morning people, everything fine ? This would be the last point we were dealing with, I decided to open a forum so it wouldn’t be so confusing. And thank you once again for the help you provided me. But it needs to check if the capacity is empty it takes the value to be sent and adds it to the next day, if the next day is empty it also adds it to the next day. Every day there must be shipping and CAP, if not, must be added for the next day. I sent you the material above and …

I knew since I read your post, that I could deploy that solution for your challenge. However that post was a very particular (and complex) logistics use case; so just share that solution with you wouldn’t be that evident.

I didn’t try to understand your workflow, I just concerned myself on replacing MA functionality. I’ve replicated your current custom workflow by: removing the Group Loop(), and replacing the ‘Moving Aggregation’ nodes with Column Expressions’ supported metanodes.

Data Wrangling _ Dynamically Ranged Moving Aggregation (no Loop) – gonhaddock

I hope it helps on time; and I think that you will be surprised with the alternative workflow’s performance.

BR