Knime 4 not reporting status in batch mode?

I’m using Knime in batch mode to run workflows.

In knime 3.7.1 I got output like :

INFO main BatchExecutor ===== Executing workflow /users/erik/test.knwf =====
SLF4J: Failed to load class “org.slf4j.impl.StaticLoggerBinder”.
SLF4J: Defaulting to no-operation (NOP) logger implementation
SLF4J: See http://www.slf4j.org/codes.html#StaticLoggerBinder for further details.
WARN KNIME-Worker-0 Node Node created an empty data table.
INFO main BatchExecutor Workflow execution done Finished in 1 sec (1942ms)
INFO main BatchExecutor ============= Workflow executed sucessfully ===============

When I run the same workflow in knime 4.0.1, I get this as output:

LF4J: Failed to load class “org.slf4j.impl.StaticLoggerBinder”.
SLF4J: Defaulting to no-operation (NOP) logger implementation
SLF4J: See http://www.slf4j.org/codes.html#StaticLoggerBinder for further details.
WARN KNIME-Worker-0 Node Node created an empty data table.
Aug 21, 2019 2:41:00 PM org.apache.cxf.bus.osgi.CXFExtensionBundleListener unregister
INFO: Removing the extensions for bundle 125
Aug 21, 2019 2:41:00 PM org.apache.cxf.bus.osgi.CXFExtensionBundleListener unregister
INFO: Removing the extensions for bundle 126

the command I’m using to run the workflow is:
/Knime -reset -nosplash -nosave -application org.knime.product.KNIME_BATCH_APPLICATION -workflowFile="/users/erik/test.knwf"

as you can see, there’s no longer a line in the output that tells me if the execution was successful.
Is there a way to turn this back on?

@ErikL I’ve experienced the same issue. 3.7.1 showed the status, whereas I could not figure out how to get the status working for 4.0.0; I haven’t tried 4.0.1 yet.

This topic was automatically closed 182 days after the last reply. New replies are no longer allowed.