Hi everyone, I hope this topic is not a repetition of an existing thread. I need to run the following workflow. [loopproblem] Here I need to process some data within a recursive loop using rows (one by one) from another table, so I need to use a chunk loop, but the problem with variables occurs. If I connect the variable ports of the Recursive Loop Start and the Chunk Loop Start, the latter does not change the rows anymore so the loop process always the same table. If I connect them the other way, I get the error that the Recursive Loop End is not connected with the corresponding Loop Start node. Could someone please explain once and for all how to connect somehow two loops or to use properly recursive loops in general? Please contact me if you need some more information or solutions :blush: Have a nice time! Silvia

Hello @ChineS , think in this case you might find Recursive Loop Start (2 ports) and Recursive Loop End (2 ports) useful. In each iteration you take only first row from table that you now feed to Chunk Loop Start and feed Loop End node without. (You can use Rule-based Row Splitter node for it with rule based on row index.) Br, Ivan

Variable stack, loop problem

KNIME Analytics Platform

mlauber71 September 29, 2021, 11:19pm 2

@ChineS you can not just mix loops. You will have to use a correct ‘wireing’. You could read more about loops here:

If you create an example that does represent your problem it might be easier to make some suggestions.

2 Likes