Association Rule Learner - Error - Node Created an empty Table

[mlauber71]

@KavyaMayya most likely you would have to adapt some settings in order to allow lower cover rates (% which your rule must cover). Also you should check how you have set up your workflow.

Here are some examples:

Need idea in cluster analysis problem

I have tried the few lines but they do not make that much sense and for the Weka nodes I had in mind they do not have the right format. So I used an older example I had from a Kaggle DS. It is just for illustration the values do not make much sense with regards to a sequence. These basic differences Weka HotSpot can deal with strings and numbers and would accept a Target (in your case if you want to differentiate between Errors and Non-Errors). This might potentially handle your duration value…

Rule Induction with Weka Rule Nodes and Yacaree Associator – mlauber71